Turning power on/off, English, Turning on the main power – Sharp PN-60TW3 User Manual

Page 11: Turning power on, Noperation mode, Ndate/time setting

Advertising
background image

9

E

ENGLISH

Turning Power On/Off

Caution

• Turn on the monitor first before turning on the computer or

playback device.

• To keep the performance of the wireless controller stable, put

the monitor in the Power off (Standby mode) state once a day.

• When switching the main power switch or the POWER

button off and back on, always wait for at least 5 seconds.

A short interval may result in a malfunction.

Turning on the main power

Main power switch

Caution

• The main power must be turned on/off with the main power

switch. Do not connect/disconnect the power cord or turn

the breaker on/off while the main power switch is on.

• For a complete electrical disconnection, pull out the main

plug.

Turning power on

1. Press the POWER button.

POWER button / Power LED

Status

Status of the monitor

Green lit

Power on

Orange lit

Power off (Standby mode)

Green flashing

Input signal waiting mode

n

Operation mode

When the monitor is turned on for the first time after being

shipped from the factory, the operation mode setting screen

will be displayed. Set it to MODE1 or MODE2.

MODE1 ....OFF IF NO OPERATION is set to ON, and POWER

SAVE MODE is set to ON. (These settings can not

be changed.)

Determines whether or not to set the monitor to go

into standby mode when there is no operation from

the remote control unit, or LAN for over 4 hours.

Power consumption in standby mode is also

minimized.

MODE2 ....Will perform standard operation.

OFF IF NO OPERATION is set to OFF, and

POWER SAVE MODE is set to OFF. These settings

can be changed.

Even after being set, changes can be made using

OPERATION MODE, located in the menu of the monitor. (See

Operation manual.)

n

Date/time setting

• If the time has yet to be set when the monitor is first turned

on, the date/time setting screen appears. Set the date and

time.

DATE/TIME SETTING

/

/

OK···[ENTER] CANCEL···[RETURN]

:

:

01

01

16

/

00

00

:

/ 20

1. Press or

to select the date and time, and

press

or

to change the numerical values.

2. Press

ENTER

.

• Be sure to set the date and time.

• The date/time setting screen will close automatically if

no operation is performed for about 15 seconds. The

date and time can be set using DATE/TIME SETTING

from the SETUP menu when the date/time setting screen

disappears.

TIPS

Set the date in “Day/Month/Year” order.

Set the time on a 24-hour basis.

The clock is maintained by the internal battery.

If you already set the time but the date/time setting

screen appears when the power is turned on, the

internal battery may be exhausted. Please contact

your local SHARP servicing dealer or service center for

assistance with battery replacement.

Estimated service life of the internal battery: About 5

years (depending on monitor operation)

The initial battery was inserted at the factory when the

monitor was shipped, so it may run out of power before

its expected operation life.

Advertising
This manual is related to the following products: