Sharp PN-60TW3 - Manual (Page 28)

28
E
Network
Setup
DHCP Server
Setup
Auto
Use the DHCP server function of the wireless controller.
Start IP / End IP:
Specify the range of IP addresses assigned to clients by the wireless controller’s DHCP
server.
Subnet Mask / Default Gateway / DNS Server:
Specify the addresses that the wireless controller’s DHCP server sets in the client.
Disable
Do not use the DHCP server function of the wireless controller.
GateKeeper You can limit access to the wired LAN from computers connected to the wireless controller by
wireless LAN.
All Pass: Allow all access to the wired LAN.
All Blocked: Block all access to the wired LAN.
Internet Only: Only allow access by web browser.
WLAN Setup Wireless LAN Set whether the wireless LAN function is used.
Mode Access Point: Use the wireless controller as an access point.
Station: Use the wireless controller as a client.
AP and Station: Use the wireless controller as both an access point and a client.
Access Point Set this when the “Mode” is “Access Point” or “AP and Station”.
SSID
Set the SSID of the wireless controller.
SSID Broadcast
Set whether SSID broadcast is used.
Band
Set the frequency bands used for wireless LAN.
* 2.4 GHz and 5 GHz cannot be used simultaneously.
* When 5 GHz is selected, 2.4 GHz devices will not be able to connect.
802.11mode
Change the communication frequency bands and the communication speed.
Channel
Set the channels that are used for wireless LAN.
Encryption
Set the encryption method for wireless LAN encryption.
Key
Set a key that is appropriate for the wireless LAN encryption method.
Channel Bandwidth
Set the channel bandwidth.
Station Set this when the “Mode” is “Station” or “AP and Station”.
Connect to Existing AP
Enter the SSID of the wireless LAN access point.
Encryption
Set the encryption method for wireless LAN access point.
Key
Set the encryption key that is appropriate for the wireless LAN access point.