Sony UniSlot Interface Adapter (25-Pin Connector) - Manual (Page 17)

15 US
Installing the Speaker
System
For the installation, refer to Startup
Guide (separate document).
• Prepare screws (not supplied) that are
suitable for the wall material and stability.
Depending on the wall material, the wall
may be damaged.
• Fasten the screws securely in the wall
beam.
• Hang the speakers horizontally on the
reinforced wall.
• Have the installation done by a Sony
dealer or licensed contractor and pay
special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall stability,
improper screw installation, natural
disasters, etc.
1
Prepare screws (not supplied) that
are suitable for the wall mounting
hole on the rear of the speaker.
2
Fasten the screw in the wall.
3
Peel off the cover on the rear of the
speaker with a safety-pin, etc.
Setting Up
Installing the Control Box
and Speakers
Mounting the Speakers on a
Wall
Notes
Speakers
Hole on the rear of the speaker
4 mm (5/32 in)
More than 30 mm (1 3/16 in)
4.2 mm
(11/64 in)
9.6 mm
(3/8 in)
Approx.
7.35 mm
(approx.
19/64 in)
Cover