Connecting your monitor – Dell P2723QE 27" 4K UHD USB Type-C Hub Monitor User Manual
Page 30
│
Connecting your monitor
WARNING: Before you begin any of the procedures in this section, follow
.
WARNING: For your safety, be sure that the grounded power outlet you plug
the power cord into easily accessible to operator and located as close to the
equipment as possible.
To disconnect power from the equipment, unplug the power cord from the
power outlet by grasping the plug firmly. Never pull on the cord.
WARNING: A certified power supply cord has to be used with this equipment.
The relevant national installation and/or equipment regulations shall be
considered. A certified power supply cord not lighter than ordinary polyvinyl
chloride flexible cord according to IEC 60227 (designation H05VV-F 3G
0.75mm² or H05VVH2-F2 3G 0.75mm²) shall be used. An alternative flexible
cord is synthetic rubber.
NOTE: Dell monitors are designed to work optimally with Dell supplied inbox
cables. Dell does not guarantee the video quality and performance when
using non-Dell cables.
NOTE: Route the cables through the cable-management slot before
connecting them.
NOTE: Do not connect all cables to the computer at the same time.
NOTE: The graphics are used for the purpose of illustration only.
Appearance of the computer may vary.
To connect your monitor to the computer:
1.
Turn Off your computer and disconnect the power cable.
2.
Connect the DisplayPort, HDMI, or Type-C cable from your monitor to the
computer.
3.
Switch on your monitor.
4.
Select the correct input source at monitor OSD Menu and turn on your computer.