HP Z40c G3 39.7" 21:9 Curved 5K IPS Monitor - Manual (Page 13)

IMPORTANT: To position and stabilize the monitor, HP recommends that two people perform these
procedures.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor upside-down on the top edge on a flat surface covered by a protective sheet made
of foam or a clean, dry cloth.
3. Push up the latch near the bottom center of the stand’s hinge (1).
4. Slide the stand out of the recess (2).
Attaching the monitor head to a mounting device
You might need additional tools such as a screwdriver (purchased separately) when you attach a mounting
device. To avoid damage to your monitor, follow these instructions.
1. Remove two screws (1) and plastic from the hinge (2), located on the rear of the monitor head.
8 Chapter 1 Getting started