Westcott FJ200 Strobe - Manual (Page 16)

5. Enable the settings option by quickly pressing the center ​ Control Dial ​ or by pressing the ​ Return |
Model ​ button once.
6. Repeat steps 2-5 to make further adjustments or press the ​ Return | Model ​ again to return to the
main control screen.
Settings Options
● Mode ​ Options: [TTL, M]
● SYNC ​ Options: [NOR, HSS, FRE]
● Channel ​ Options: [AU, 01-31]
● Group ​ Options: [A, B, C, D, E, F, G, H, I, J, L, O, P, Q, S, U]
● Wireless ​ Options: [OFF, TTL-ALL, RT/ID]
● RT ID# ​ Options: [00-99]
● Optical ​ Options: [OFF, ON]
● Beep ​ Options: [OFF, ON]
● TTL->M ​ Options: [OFF, ON]
● Auto-Off ​ Options: [OFF, 10, 30]
● Screen ​ Options: [MIN, MID, MAX]
● Factory Reset ​ Options: [NO, YES]
NOTE:
​ SYNC ​ option ​ FRE ​ is only available when the Mode setting option is set to ​ Manual [M] ​ .
NOTE: ​ Optical ​ option is only available when the Mode setting option is set to ​ Manual [M] ​ .
NOTE: ​ Mode ​ option ​ TTL ​ is only available when the ​ Wireless ​ setting option is set to ​ TTL-ALL ​ or ​ RT/ID ​ .
FJ200 Battery: Performance and Care
FJ200 Battery Performance
The FJ200 Lithium-Polymer Battery (14.8V 37Wh, 2500mAh) is capable of 450+ full-power flashes with
the modeling lamp disabled and screen brightness set to
​ MIN ​ .
FJ200 Charging & Life Expectancy
The average charge time is 2 hours from complete discharge. The FJ200 Lithium-Polymer Battery (14.8V
37Wh, 2500mAh) will achieve at least 300 complete charge cycles
​ (@80% after 300) ​ . Continued usage
beyond the expected charge cycles will result in diminished performance and the ability to hold a
charge. Avoid charging and using the battery outside of the stated operating temperatures
​ 50~113°F /
10~45°C ​ as it will affect the overall performance of the battery and strobe. Preserve the longevity of the
battery by storing at roughly ~40% capacity at room temperature in a dry environment and recharge to
this capacity at least every 3 months when not being used.
15