Godox VING V850II Li-Ion Flash Kit - Manual (Page 14)

- 31 -
11. Wireless Flash Shooting: Radio (2.4G)
Transmission
● V850II has 2.4G radio transmission (Master/Slave)
● Wireless mode setting: Long press<
> button and hold for 2
seconds until< > icon is blinking. Turn the Select Dial to set
from OFF/Master(M)/Slave(S) mode.
● Channel setting: Long press <
> button and hold for 2
seconds until the figure besides the CH is blinking. Turn the
Select Dial to choose the channel from 1~32.
● Group setting: Short press <
> button to select group. In
Master mode, groups can be selected from M/A/B/C/D/E; while in
Slave mode, groups can be selected from A/B/C/D/E.
● As V850II adopts Godox wireless X system, it is compatible with
AD360II-C, AD360II-N, TT685C, TT685N, X1T-C, X1T-N
wireless control, etc.
● See the picture below:
12. Wireless Control Function
● The flash unit is built in with a Wireless Control Port (6) so that
you can wirelessly adjust the power level of the flash and control
the on-or-off of your flash, focus assist beam and buzzer, as well
as trigger the flash.
● To control the flash wirelessly, you need a Godox FT
series remote control set (on-camera and on-flash).
Insert its receive end into the Wireless Control Port
(6) on the flash and insert the transmit end
into the camera hot shoe. Settings made
on the hotshoe-mounted transmit and
receive ends will be
wirelessly communicated to
the flash. Then you can
press the camera shutter-
release button to trigger
the flash. You can also hold
the transmit end at hand to
control your off-camera
flash.
13.Sync Triggering
The Sync Cord Jack (7) is a Φ2.5mm plug. Insert a trigger plug
here and the flash will be fired synchronously with the camera
shutter.
● For full instructions on the use of FT series remote control,
see its user manual.
Transmission distance is
about 100 meters