Philips H-Line 55BDL3202H 55" Full HD Digital Signage LED Display - Manual (Page 32)

55BDL3202H
21
Position
Adjust the position of this display in the screen matrix.
Example: 2 x 2 screen matrix (4 displays)
H monitors = 2 displays
V monitors = 2 displays
1 2
3 4
H monitors
V monitors
Position
Example: 5 x 5 screen matrix (25 displays)
H monitors = 5 displays
V monitors = 5 displays
1 2
6 7
3 4
8 9
5
10
11 12 13 14 15
16 17 18 19 20
21 22 23 24 25
H monitors
V monitors
Position
Frame comp.
Enable or disable the frame compensation function. If you
select {On}, the display will adjust the image to compensate
for the width of the display bezels in order to accurately
display the image.
{On}
{ Off }
Frame comp.H
Adjust the horizontal frame compensation.
Frame comp.V
Adjust the vertical frame compensation.
Switch on delay
When multiple displays are connected, adjust the power-
on delay time (in seconds) for each display to reduce the
power load.
RS232-Routing
Select the control port.
• {
RS232 }: Select RS232 Control.
• { LAN(RJ-45) }: Select LAN control.
• { IR }
Select the operation mode of the remote control when
multiple displays are connected via an RS232C connection.
• {
IR Control }
• { Normal }
All displays can be operated normally by the remote control
unit.
• {
Primary }
Designate this display as the primary display for remote
control operation. Only this display can be operated by the
remote control.
• {
Secondary }
Designate this display as the secondary display. This display
can not be operated by the remote control, and will only
receive the control signal from the primary display via the
RS232C connection.
• {
Control Monitor-ID }
Select the ID number for the IR control of the display via the
RS232C connection.
• {
Card OPS RS232 }:
Select RS232 Control. (Only available when OPS is started.)