NEC 40,000-Lumen 4K Laser Installation Projector - Manual (Page 185)

168
8. Appendix
❿
Indicator Messages
This section helps you resolve problems you may encounter while setting up or using the projector.
POWER Indicator
Indicator display Projector status Procedure
Off Power is off. –
Flashing Green (short flashes) Preparing to power up or cooling the main
unit
When the projector is in the standby state,
the firmware is ready to be updated Wait a while.
Green (twice per cycle) Firmware is ready to be updated –
Green (long flashes) Off timer (enabled)
Program timer (off time enabled) –
Orange (long flashes) Program timer (on time enabled) –
Lit Green Power on –
Orange Standby mode –
STATUS Indicator
Indicator display Projector status Procedure
Off No problem –
Flashing Green (short
flashes) Shutter is closed –
Green (long
flashes) Power on (The light mod-
ule is turned off.) –
Orange Button has been pressed
while projector is in key
lock mode The projector’s keys are locked. The setting must be can-
celed to operate the projector. (
→ page 36 , 120 )
Projector’s ID number
and remote control’s ID
number do not match Check the control IDs. ( → page 121 )
Projector cooling Wait a while.
Red Error occurring Contact your distributor or service personnel. Let us know
the details displayed on the liquid crystal indicator panel
then.
Lit Green Power on –
Orange Standby mode –
Red Error requiring service
support Ask your distributor or service personnel for repair. Let us
know the details displayed on the liquid crystal indicator
panel then.