InFocus IN1026 Advanced 4200-Lumen WXGA 3LCD Projector - Manual (Page 70)

www.infocus.com
Expand
70
7C:6F:F8:4E:B9:2F
192.168.1.100
Expand
Network
Network setting
Network information
MAC address:
IP address
Network menu
Network
This function is designed to allow the
computer control on the projector remotely
over your local network.
Preparation
1. Required equipment: Projector, computer,
network cable
2. Connection:
Connect your projector to a router or switch
in the LAN with normal or jumper network
cable. In case a normal network cable failed
to connect successfully, use a jumper cable
instead.
3. Turn on the computer. The LAN port on
computer and projector are flashing after
power on the projector.
Operation steps
1. Power on your projector.
2. Acquire the IP address, with DHCP set to
on and auto IP allocation set to On. (You
may set DHCP to Off and set up IP address
manually if you are somehow familiar with
networking.)
3. Enter the network setup menu
1. Press <MENU> button on remote control
or top of the control panel, press 
button to select network icon.
2. Press  button select network
settings and press <OK> button to enter.
Display the MAC address of
wired network.
Display the IP address of
wired network.
3. Press  button to set DHCP On to
obtain an IP address, subnet, gateway
and DNS automatically, and press <OK>
button to confirm.
Press  button to set DHCP Off,
then press <OK> button to enter an IP
address, then press  button to select
subnet, gateway and DNS, and press
<OK> button to confirm.
MAC
address
IP address
： Adjust ： Next OK ： Back MENU
LAN
DHCP
IP address
Subnet
Gateway
DNS
Network setting
Set
On
Cancel
. . .
. . .
. . .
. . .
： Adjust ： Next OK ： Back MENU
Off
192 . 168 . 1 . 100
255 . 255 . 255 . 0
192 . 168 . 1 . 1
192 . 168 . 1 . 1
LAN
DHCP
IP address
Subnet
Gateway
DNS
Network setting
Set Cancel