Onkyo A-9110 2-Channel 100W Integrated Amplifier - Manual (Page 6)

6
Before use
1. SPEAKERS terminals: Connect speakers with speaker
cables. (  p9)
0 North American models are banana plug ready. Use
plugs with a diameter of 1/8" (4 mm).
0 Not all models support connection with Y plugs.
2. Power cord (  p12)
3. GND terminal: The ground wire of the turntable is
connected.
4. PHONO MM jacks: Use an Analog audio cable to connect
a Turntable that uses an MM type cartridge. (  p11)
5. LINE IN jacks: Input audio signals from a playback device
with an analog audio cable. (  p10)
6. LINE OUT jacks: Use an Analog audio cable to output
audio signals to recording equipment, such as a cassette
tape deck.
To select the input source for recording, use
the INPUT dial on this unit or use the remote controller.
7. SUBWOOFER PRE OUT jack: Connect a powered
subwoofer with a subwoofer cable. (  p10)
8. RI REMOTE CONTROL jack: This jack is for linking when
you connect an Onkyo CD player, tuner, network audio
player, or RI dock that has an RI (“Remote Interactive”)
jack. (
 p11)
Rear Panel
 
     
SN29403405_A-9110_En_1806XX.book 6 ページ ２０１８年７月５日 木曜日 午後２時４３分