Eaton Electrical 1000 - Manual (Page 23)

EATON Power Xpert ® Gateway Series 1000 Card User’s Guide S 164201670 Rev 1 19
Chapter 2
Configuring the Card
NOTE If DHCP is disabled and you will be using host names for servers, such as the mail
server, Network Time Protocol (NTP) server, SNMP hosts, Modbus
® /TCP hosts, or trap
recipients, enter the IP address of your network DNS Server (see “Network Configuration” on
page 16).
NOTE You must be logged in as admin to configure the card. Once you have logged in as
admin, it is important to completely exit the browser to set the security level back to the
standard read-only level.
This section explains:
S
Changing the passwords
S
Setting the date and time
S
Configuring SNMP options and managing from an SNMP NMS
S
Configuring Modbus TCP/IP options
S
Configuring e-mail notification
S
Configuring the Powerware Environmental Monitoring Probe (EMP)
S
Configuring auto discovery settings