Estate E-SC 1102 - Manual (Page 10)

ATTENTION: Study the control board and read this section
thoroughly before attempting to operate your gate opener.
Control Board Layouts
Warnings:
•
Before attempting any job on the control board (connections, maintenance), turn
off electrical power and unplug the support battery.
•
Install a surge protector upstream of your opener, the opener is not power surge
proof nor will power surge damage be covered under warrantee.
•
Always separate power from control and safety cables (push-buttons, receivers,
photocells, etc.). To avoid any electrical noise, use separate sheaths or a shielded
cable (with earthed shield).
La
yo
u
t o
f M
a
s
te
r C
o
n
tr
o
l B
o
a
rd
La
yo
u
t o
f S
la
ve
C
o
n
tr
o
l B
o
a
rd
LED Programming LEDs
P Power ON and diagnostics LED
P1 “Function” programming push-button
P2 “Value” programming push-button
F1 Battery and motor fuse - F15A
J1 Accessories Terminal board
J2 Transformer Terminal board
J3 Motor connection terminal
J4 Battery connector
J5 Minidec connector/RP receiver
P Power ON and diagnostic LED
F1 Battery and motor fuse - F15A
J2 Bus connection terminal board
J3 Motor connection terminal board
J4 Battery connector
2.1