EverFocus NEV10 EZN850 - Manual (Page 26)

EZN850
26
Ö ESC: (Reserved).
Ö Manual: (Reserved).
3. Click the SET key when you finish all the settings.
4.4.2.3 WHITE BALANCE Control
The screen color can be adjusted by using the WHITE BALANCE function.
1. Please direct the arrow to point to “WHITE BAL” on the SETUP menu by
clicking UP (c) or DOWN (d) key.
2. Please select the mode you would like to operate by clicking LEFT (e) or RIGHT
(f) key.
Please select one of the 3 modes below:
Ö ATW (Auto Tracking White Balance): This mode can be used within the color
temperature range from 2,500°K to 8,300°K (eg, fluorescent light, outdoor,
sodium vapor lamp or inside tunnels).
Ö AWC (Auto White Balance Control): Click the SET key while the camera is
directed at a piece of white paper to get the optimum state under the present
illumination. If the environment and the light source are changed, you need to
BRIGHTNESS
BRIGHTNESS |+++++++++| 25
SHUTTER
> MANUAL 1/50
SETUP
LENS MANUAL
> SHUTTER MANUAL <┘
WHITE BAL. ATW
BACKLIGHT OFF
AGC MIDDLE
DNR LOW
SENS-UP ___
SPECIAL
<┘
EXIT
SETUP
LENS MANUAL
> SHUTTER ESC <┘
WHITE BAL. ATW
BACKLIGHT OFF
AGC MIDDLE
DNR LOW
SENS-UP AUTO
<┘
SPECIAL <┘
EXIT
Note:
With DC lens, the shutter speed is fixed as 1/60 for NTSC and 1/50 for PAL.