Eureka 4500 - Manual (Page 11)

11
To Replace New Bag:
3. Fold sides on new paper bag below bag collar.
4. Align bag collar hole and notch with hose tube.
5. Place rear of bag collar on ledges. Push back
and rotate upward until firmly in place. Make
sure collar snaps into position and hose tube
is securely inserted into bag collar hole.
6. Tuck bag into bottom and along sides.
7. Align front cover tabs and close cover. Make
sure paper bag is not caught under the front
cover.
4
Bag
Side
We recommend using only Genuine Eureka
Standard AA Bags, part number 58236.
6
How to Check and Clear Hose Blockages
Low suction or poor pickup may be due to a blockage in the vacuum cleaner.
1. Remove hose and check suction at end of hose - if little or
no suction, check disposable dust bag. Change if needed. If
no improvement proceed to Step 2.
NOTE: Turn off the switch and unplug the electrical cord
before clearing hose.
2. Remove the front bag cover. To remove hose adapter from
opening, twist hose adapter clockwise and lift upward.
Once the hose is removed from the cleaner check for any
obstructions that may be in the hose. Any obstructions can
be removed by using a blunt instrument to clear the hose.
Flexing the hose may help loosen the clog.
3. Reinstall the hose after clearing the clog. Make sure the
hose is inserted into the top of the vacuum cleaner.
NOTE: If no improvement in performance on carpet, proceed
to following page.
5
Bag
Collar
5
3
2. Remove front bag cover.
3. Remove hose adapter by twisting
clockwise and lifting upward. Check hose
for blockages.
Hose Adapter
3
1. Remove hose and
check suction at
end of hose.
1
4. Reinstall the hose
and replace front
bag cover.
4