Transpose buttons, Pitch wheel and modulation wheel, Variation button – Kurzweil PC4-7 76-Key Performance Controller and Studio Workstation Synthesizer User Manual

Page 8

Advertising
background image

The Front Panel

8

TRANSPOSE Buttons

The TRANSPOSE buttons can be used to change the tuning of notes played on the PC4

keyboard in semitones (also known as half steps). The current transpose amount is shown

in the top line of the display. Press both TRANSPOSE buttons simultaneously to reset the

transposition to 0.

Pitch Wheel and Modulation Wheel

Use each wheel to respectively perform pitch bends or vary the modulation amount. The

Modulation Wheel will control modulation for each Program or Multi. The name of the

current modulation assignment is shown in the display when the wheel is moved.

VARIATION Button

Pressing the VARIATION button will perform an assigned variation for each Program

or Multi. The name of the current assignment is shown in the display when the button is

pressed.
The VARIATION button has two states, off (not lit) and on (lit). The VARIATION button

will typically modify the sound by adding an orchestral string section or synth pad layer, or

enabling an effect.
For KB3 Organ Programs, the VARIATION button controls the Rotary Speaker speed,

changing between fast and slow. The display shows “KB3” when a KB3 Program is selected.

CONTROL Section

The CONTROL section is used to control various Program and Multi parameters.
In Program Mode:

The knobs, sliders, and buttons control synthesis and FX parameters

for the current Program. Controller assignments can be adjusted or set to user-assignable

parameters in Program Edit Mode.
In Multi Mode:

The knobs, sliders, and buttons typically control Zone volume, synthesis

and FX parameters for the current Multi. Controller assignments can be adjusted or set to

user-assignable parameters in Multi Edit Mode.
In Program and Multi Mode:

When a KB3 Organ Program is selected, some of the knobs,

sliders, and buttons may perform Organ functions labeled on the front panel. The display

shows “KB3” when a KB3 Program is selected.

ARPEGGIATOR Section

Use the ARP and LATCH buttons to control the PC4’s Arpeggiator.

Advertising