Eureka 4670 Series - Manual (Page 15)

15
To remove HEPA cartridge filters
1. Push down latch and pull filter cassette back.
2. Then lift filter up and remove.
To replace HEPA cartridge filters
1. Place bottom tabs of filter cassette into slots.
2. Rotate filter toward cleaner.
3. Push upward on the latch to secure into place.
NOTE: To have the benefit of a sealed HEPA system,
you must use one of the HEPA cartridge
filter systems.
To remove HEPA/Micron filters from
filter frame .
1. Push down latch and pull filter frame back.
2. Then lift filter up and out of filter frame.
To replace HEPA/Micron filters into
filter frame .
1. Place new filter in filter frame. Place bottom tabs
of filter frame into slots.
2. Rotate filter frame toward cleaner.
3. Push upward on the latch to secure into place.
HEPA Cartridge Filters
(Only for models
with HEPA.)
Check the HEPA filters with each disposable dust bag
change. Replace twice a year or after every six bag
changes.
HEPA/Micron Filters in Filter Frame
(Only for models with HEPA/Micron filter frame)
Check the HEPA/Micron filter with each disposable
dust bag change. Replace twice a year or after every
six bag changes.
Latch
Tabs
Filter cartridge
(One complete
unit)
Filter Frame plus
filter (depending
on your vacuum
model)
,


 

y z
P
Q
Filter Filter
Frame
Motor Filter
Check the motor filter with each disposable dust bag
change. Clean or replace as needed.
To Clean Motor Filter
1. Remove filter from inside bag compartment, lower
left side.
2. Shake filter to remove excess dust. If necessary, the
filter can be cleaned by vacuuming with another
cleaner.
3. Reinstall filter with stiff/printed side down. Slide
under back ledge and filter retainer. Install with
colored/smooth side down.
Back Ledge 3
Filter Retainer 3
,



y
z
||
3 1 and