Synology DiskStation DS620slim 6-Bay NAS Enclosure - Manual (Page 11)

11 Chapter 2: Hardware Setup
5 Place the bottom panel back by slid ing in the front bottom panel first as illustrated below. Place back and tighten
the 4 screws you removed in step 3.
6 Reconnect the cables you removed in step 1, and then press and hold the power button to turn on your
Synology NAS.
To make sure Synology NAS recognizes the new memory capacity:
1 Install DiskStation Manager (DSM). See Install DSM on Synology NAS for more information.
2 Log in to DSM as admin or a user belonging to the administrators group.
3 Check Total Physical Memory in Control Panel > Info Center .
If your Synology NAS does not recognize the memory or does not start up successfully, make sure that the
memory is installed correctly.
To remove the RAM Module:
1 Follow step 1 to 3 of the "To install a RAM module:" section to shut down your Synology NAS, disconnect the
cables, and then remove the bottom panel.
2 Push the levers on both sides of the memory module outwards. The module will be released from the slot.
3 Hold the memory module by its notches and remove it from the slot.
4 Place the bottom panel back. Place back and tighten the screws removed in step 1.