3 function selection, How to use the function selection, Function selection – Fujitsu Ricoh Fujitsu fi-7700 Document Scanner User Manual
Page 81: 3 function, Appendix glossary introduction index contents top
Chapter 3 How to Use the Operator Panel
TOP
81
This section explains about the Function Selection.
When you press the [
] or [
] button while the [Ready]
screen is displayed, the [Function Selection] screen is
displayed.
By using the Function Selection, you can configure the
application you want to launch when you press the [Scan/
Enter] button while the [Ready] screen is displayed.
The configured applications are applied to the application
numbers (F00 to F50/SOP) that are displayed in the indicator.
How to Use the Function Selection
1
Press the [Power] button on the operator panel.
The [Ready] screen is displayed on the LCD.
The indicator displays [F00] when the power has just been turned
on.
2
Press the [
] or [
] button.
The [Function Selection] screen is displayed on the LCD.
3
Press the [
] or [
] button and select a parameter, then
press the [Scan/Enter] button to confirm.
For more details about the setting parameters, refer to
Configurable in Function Selection" (page 82)
.
The setup is completed when the LCD displays the [Ready] screen.
The indicator displays the configured parameter.
In this example, the indicator displays "F02" because "No.02" is
selected.
3.3 Function Selection
1 [Power] Button
3 [
]/[
] Button
[Scan/Enter] Button
2 [
]/[
] Button
Menu
Scan/Enter
Check
Powe
Power
Stop/Clear
Menu
Scan/Enter
Check
Power
Stop/Clear
[fi-7600]
[fi-7700/fi-7700S]
HINT
When "No.00" to "No.50" are selected, the indicator displays
"F00" to "F50".
When "SOP" is selected, "SOP" is displayed on the indicator.
SOP indicates the Software Operation Panel.