Epson EL 486UC - Manual (Page 21)

6. Plug the other end of the power cord into an appropriate
grounded electrical outlet or into the power outlet on the
back of the system.
Caution
Before you plug the monitor’s power cord into the back
of your computer, make sure the monitor’s power
requirements do not exceed 1 Amp.
Connecting a Printer or Other Device
Your computer has one parallel and two serial ports. To
connect a printer or other peripheral device, follow the
appropriate instructions below.
Using
the
parallel port
Follow these steps to connect a parallel printer to your
computer:
1. Place the printer next to the computer so that the backs are
facing you.
2. Align the connector end of the printer cable with the
PARALLEL port and plug it in. If the connector has retaining
screws, tighten them.
3. Connect the other end of the cable to the printer. To secure
the cable, squeeze the clips at each side of the printer port
and push them into place.
4. Plug the printer’s power cord into an appropriate grounded
electrical outlet.
Setting Up Your System 1-5