QSC Audio AcousticPerformance Series Loudspeaker (Black) - Manual (Page 2)

2 QSC, LLC / AcousticPerformance™ Series Loudspeaker Application Guide
THE A
COUSTIC
P
ERFORMANCE
™ SERIES. THE NAME
SAYS IT.
The highly versatile AcousticPerformance Series comprises six models: three trapezoidal two-way models, a subwoofer, a
two-way model that can be used equally well as a floor monitor wedge or as an upright high-power main loudspeaker, and a
coaxial two-way model with 60- and 40-degree side angles for use as an upstage or downstage monitor.
All the two-way models are designed with Directivity Matched Transition (DMT™), in which the compression driver’s waveguide
is carefully designed so its coverage angle matches up with that of the woofer at the crossover transition. This results in
smooth, coherent, and natural-sounding frequency response, even when the listener is off-axis.
All except the AP-212sw, AP-4122m, and AP-5122m are available in either black (RAL 9011) or white (RAL 9010). The
AP-4122m and AP-5122m are available only in black RAL 9011.
The AP models are well suited for high-quality systems, installed and mobile alike.
The model lineup
AP-5102
A 10-inch two-way loudspeaker with 105° coverage. It can be operated in either full-range
passive mode (using the internal crossover) or active (bi-amped, with an active crossover).
Bi-amped, the LF and HF drivers both have 8-ohm impedances. In full range, the system
also has an 8-ohm impedance.
The trapezoidal enclosure has no handles but does have
M10 threaded inserts that make it suitable for flying
or yoke mounting in a permanent installation.
• HF: Compression driver with 76 mm
(3 in) voice coil
• LF: 10 in driver with 76 mm (3 in)
voice coil
• Max continuous SPL at 1m: 121 dB
• Recommended crossover: 950 Hz,
48 dB/oct slopes
• Intrinsic Correction™ available in
select QSC processors
AP-5122
A 12-inch two-way loudspeaker with 90°
coverage. It can be operated in either
full-range passive mode (using the internal
passive crossover) or active (bi-amped, with
an active crossover). Bi-amped, the LF and HF
drivers both have 8-ohm impedances. In full range,
the system also has an 8-ohm impedance.
The trapezoidal enclosure has no handles but does have
M10 threaded inserts that make it suitable for flying or yoke
mounting in a permanent installation.
• HF: Compression driver with 76 mm (3 in) voice coil
• LF: 12 in driver with 76 mm (3 in) voice coil
• Max continuous SPL at 1m: 121 dB
• Recommended crossover: 950 Hz, 48 dB/oct slopes
• Intrinsic Correction™ available in select QSC processors