Extron electronic MDA 2V EQ - Manual (Page 8)

VersaTools® MDA EQ Series • Installation and Operation VersaTools® MDA EQ Series • Installation and Operation
Installation and Operation, cont’d
2-3
Mounting the MDA EQ Series
The MDA EQ mini distribution amplifiers can be set on a table;
mounted on a rack shelf; attached to a projector; or mounted
under a desk, podium, or tabletop.
Tabletop use
Four self-adhesive rubber feet are included with the MDA EQ.
For tabletop use, attach one foot at each corner of the bottom
side of the unit and place the unit in the desired location.
Rack mounting
For rack mounting, do not install the rubber feet. Mount the
distribution amplifier on a 19" 1U VersaTools
® rack shelf (Extron
part #60-190-20 or 60-604-20), a standard 1U Universal or Basic
rack shelf (Extron part #60-190-01 or 60-604-01), or a Universal
or Basic 6-inch Deep Rack Shelf (Extron part #60-190-10 or
60-604-10
).
Only products in the VersaTools and IP Link lines can be
mounted on a VersaTools shelf. Any 1U rack-mountable
Extron product can be mounted on the standard shelf.
1 . If feet were previously installed on the bottom of the
MDA, remove them.
2 . Mount the MDA EQ on the rack shelf, using two 4-40 x
3/16" screws in opposite (diagonal) corners to secure the
unit to the shelf.
3 . Install blank panel(s) or other unit(s) on the rack shelf.
2-2
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Mounting MDAs on a VersaTools rack shelf
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
1/4 Rack Width Front False
Faceplate
1/2 Rack Width Front False
Faceplate
Mounting an MDA EQ on a standard rack shelf