Extron electronic MDA 2V EQ - Manual (Page 9)

VersaTools® MDA EQ Series • Installation and Operation VersaTools® MDA EQ Series • Installation and Operation
Installation and Operation, cont’d
2-4 2-5
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
Mounting an MDA EQ on a 6-inch rack shelf
Furniture mounting
To furniture-mount the MDA EQ, use the optional under-desk
mounting kit (part #70-212-01), as follows.
Preparing the MDA EQ for under-desk mounting
1 . If rubber feet were previously attached to the bottom of the
unit, remove them.
2 Attach the mounting brackets to the MDA EQ with the
provided machine screws as shown in the previous figure.
3 . Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket’s screw holes.
4 . Drill 3/32" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep
in the mounting surface at the marked screw locations.
5 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than ¼" of the screw head protrudes.
6 . Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7 . S lide the unit slightly forward or back, then tighten all four
screws to secure it in place.
Projector mounting
To projector-mount the MDA EQ, use the optional projector
mounting kit (part # 70-217-01) as follows.
Ceiling
Projector
Projector
Mounting
Bracket
Mounting
Bolt
Projector-mounting an MDA EQ
1 . If rubber feet were previously installed on the bottom of
the unit, remove them.
2 . Attach the mounting brackets to the MDA EQ with the
provided machine screws.