Eureka Tundraline User Manual

Your tent is ready

Advertising
background image

Component List:

1 Tent Body/Fly, 1 Carry Bag, 2 Poles, 1 Pole Bag,

1 Stake Bag w/Stakes, 8 Attached Guys w/sliders

fig.1

fig.3

fig.4

fig.5

fig.6

fig.7

fig.8

fig.11

fig.10

fig.9

fig.7

• At the side of the tent, stake out the

web loops at each pole end. Work

your way around the tent, adjust

the stakes, pulling the fabric taut to

square the tent and remove floor

wrinkles.

See fig. 9

• This is a tension tent, therefore, do

not depend upon staking alone to

keep your tent upright and secure .

It’s IMPORTANT that you properly guy out this tent. See fig.11

1. The Tundraline has 4 triangular guy lines, one at each corner attached to

a pole sleeve. Pull out and stake these first.

2. Next, pull out and stake the 2 guys that lead from the peak at each end.

3. Pull out and stake down the last 2 guy lines from the sidewall .

• If necessary, adjust the tension on

the vestibule webs to trim the roof.

See fig.10.

• Also, if necessary, move the sliders

to adjust the tension on the guy

lines to properly trim the tent walls.

See fig.11

• Move to the opposite end of the

tent. Grasp the vestibule web

/loop and pull the tent fabric

taut to raise the structure. This

is not a freestanding tent. Therefore, you must stake out this web loop before

proceeding.

See fig. 8

YOUR TENT

IS READY!

REV. B 4.09

ASSEMBLY OF THE
TUNDRALINE TENT:

Take down: Open doors and pull up stakes. Pull posts out of the grommets.

Remove the poles, collapse them and stow. Fold the tent into thirds. Lay the

poles across the tent, roll up both towards a door and stow all.

• Assemble one half of a

shockcorded pole. Try

to prevent pole sections

from snapping

together, as this can

damage the pole ends.

Make certain each

insert end has seated

firmly into its ferrule.

Do not drop tent bag or pole bag on its end. Do not bounce tent bag

on its end to get the tent out. These actions may cut the shock cord

and/or damage the pole ends.

• Slide the assembled pole half into the sleeve. Push the pole and pull the

sleeve toward you, until the locking end tip pokes out from the opposite side.

See fig. 2 and 3

ASSEMBLY:

• Unpack the carry bag and separate all the parts. Unroll and unfold the

tent and lay it on the ground with the black side down. If windy, place

A into the wind. Stake down the web loop at A.

See fig. 1

• There is a locking post at each end

of the poles. Fit these posts into

the web grommets at the sleeve

ends to create an arch and

maintain tension.

See fig. 5 and 6

• If not already staked, go to one

end of the tent and drive a

stake through the web loop at

the bottom of a vestibule.

See fig. 7

A

fig.2

• Push the rest of the pole into the

sleeve, assembling it as you work.

See fig.4

• Repeat this with the second pole and

sleeve at the other end of the tent .

Advertising
Table of contents