Eureka Sunrise User Manual

Your tent is ready

Advertising
background image

High/Low Door

ASSEMBLY INSTRUCTIONS
FOR THE SUNRISE TWO
POLE DOME TENTS

Component List:

1 Tent

2 Tent Poles 1 Carry Bag 1 Rain Fly

2 Fly Rods 1 Pole Bag

1 Gear Loft

4 Mesh Organizers

1 Stake Bag/Stakes

Once the tent is securely staked down,

spread the rain fly out upside down.

Find the web pockets at the

edges. Place the ends of the fly

rods into the pockets. Wrap

the hook and loop fasteners

around the rods to hold it in

place. See Fig. 8, 9 & 10.

Turn the fly right side up and

drape it over the top of the

tent. The Eureka! logo should

be over the front door. Reach

under the fly and wrap the

hook and loop straps around

the poles to secure the fly to

the tent frame. See fig. 11.

Fasten the shock

corded J-hook at

each of the corners

of the fly, to the

rings on corners of

the tent. See fig.12.

NOTE:

Do not drop tent bag or pole bag on its end. Do not bounce

tent bag on its end to get the tent out. These actions may

cut the shock cord and/or damage the pole ends.

REV E 4.09

Unroll and unfold the tent and lay it on the ground. If it’s

windy, stake down one front corner into wind.

Assemble all of the shock corded poles. Keep the pole

sections from snapping together, as this can damage the

pole ends. Make certain each plain end has been properly

seated into the metal ferrule. Lay the poles side by side

and divide according to length. Long for the tent and short

for the fly.

Place a corner pin into the end of

one of the poles.

See fig. 3.

At the opposite end, with the pole in

one hand and a pin & ring in the

other, feed the pole up, bending it

evenly along its length to create an

arc. Make sure the ferrules do not

get caught on the sleeves. Place

the pin into the end of the pole to

maintain tension. Repeat with the

other pole. See fig 4.

The two long poles

cross at the center

through the sleeves

and run corner to

corner. See fig 1 & 2.

fig.2

fig.3

fig.4

fig.8

fig.10

fig.11

fig.9

fig.6

fig.7

fig.1

Start at the bottom and attach all the

clips to the poles to create a

freestanding tent. See fig 5.

Place the tent in the desired location.

Stake the tent down through the

corner web loops. Stake the

opposite corners while applying

tension to smooth the floor wrinkles.

It works best to do this before you

add the fly. See fig 6 & 7.

NOTE: General purpose stakes are

included but snow or sand stakes

can be purchased at a Eureka!

dealer.

fig.12

YOUR TENT IS READY!

NOTE: In strong winds, tie extra cords

to the storm loops on the fly and stake

down so that the cords are tight.

Take down: Pull up stakes and open doors.

Remove the fly. Pull pins out of the poles. Unclip,

collapse the tent poles and stow in the pole bag.

Fold the tent/fly. Roll up both along with the pole bag

towards the door and stow all in the main bag.

fig.5

Mesh Organizers for small accessories. This tent is equipped

with hanging mesh pockets for small accessories and water

bottles. Do not keep food in the tent. A hungry animal that

smells food will chew or claw through fabric.

Optional equipment: Floor Saver, placed under the tent,

protects floor and keeps it clean.

Water

Bottle

Pocket

Water

Bottle

Pocket

Corner

Organizer

Wall Hanger

with Mirror

Advertising
Table of contents