Enterasys Networks Enterasys SecureStack A2 A2H124-48P - Manual (Page 31)

SecureStack A2 PoE Installation Guide 3-1
3
Hardware Installation
This chapter provides instructions to install the A2H124‐24P and A2H124‐48P. Unless
otherwise noted, the instructions apply to all switches. Follow the order of the sections
listed below to correctly install the switch.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the switch to check for any exceptions to the supported
features and operation documented in this guide.
For information about... Refer to page...
Considerations Prior to Installation 3-2
Required Tools 3-2
Unpacking the Switch 3-2
Installing the Switch on a Flat Surface 3-3
Connecting Stacking Cables 3-7
Configuring Switches in a Stack 3-9
Connecting AC and PoE Power 3-12
Connecting to Console Port for Local Management 3-14
Connecting to the Network 3-19
Installing Optional Mini-GBICs 3-22
Completing the Installation 3-32