eMachines EL1200 Series - Manual (Page 58)

Chapter 3: Troubleshooting
48
4 Remove the disc from the drive and mark it with
a permanent marker.
5 If multiple discs are required, insert a new disc
when prompted, then click OK. Continue
recording discs until the process is complete.
Recovering pre-installed software and
drivers
As a troubleshooting step, you may need to reinstall
the software and device drivers that came pre-installed
on your computer from the factory. You can recover
using either your hard drive or the backup discs you
have created.
• New software
—If you need to recover software
that did not come pre-installed on your
computer, you need to follow that software’s
installation instructions.
To recover your pre-installed software and drivers:
1 Click (Start), All Programs, eMachines, then click
eMachines Recovery Management
. eMachines
Recovery Management opens.
- OR -
If you are recovering from your driver and
application recovery disc, insert it into the disc
drive, then go to Step 3 after the eMachines
Application Recovery main menu opens.
Important
Write a unique, descriptive label on each disc, such as
“Windows Recovery Disc 1 of 2.” or “Apps/Drivers Recovery
disc.”