Marshall Stanmore III Bluetooth Speaker System (Black) - Manual (Page 6)

006 STANMORE III - FULL ONLINE MANUAL
BACK TO INDEX
INSTRUCTIONS ENGLISH
GETTING STARTED
I. Connect the mains lead to the mains input on your speaker, then connect
the mains plug to the wall socket.
II. Use the power switch to turn the speaker on.
III. Download the Marshall Bluetooth app and follow the in-app instructions
to set up your speaker.
Important: Always ensure that the mains lead, plug and speaker are
compatible with your mains supply and wall socket.
Caution: Always unplug the mains lead from the wall socket before
disconnecting it from the speaker.
BLUETOOTH PAIRING
I. Use the source button to select Bluetooth.
II. Push and hold the source button until the Bluetooth LED pulses red.
III. Select STANMORE III from your audio device’s Bluetooth list.
Stanmore III can be connected to two Bluetooth devices at the same time. If a
connected device is playing, a second connected device cannot start playing
until the first device is paused.
CONNECTING AN AUX DEVICE
I. Connect a 3.5 mm stereo jack to the AUX input on the top of the speaker.
II. Connect the other end of the lead to the audio output on your audio source.
III. Use the source button to select AUX.
Note: Audio leads are not included.
CONNECTING AN RCA DEVICE
I. Connect a lead with RCA jacks to the RCA input on the back of the speaker.
II. Connect the other end of the lead to the output on your audio source.
III. Use the source button to select RCA.
Note: The turntable must be equipped with an RIAA amplifier or connected via
a separate preamplifier. Audio lead and RIAA amplifier are not included.
NETWORK STANDBY MODE
Stanmore III will go into network standby if left unused for 10 minutes to save
energy. Any connected Bluetooth device will be disconnected.
Interact with any control or button on the top panel, reconnect a Bluetooth
device or play anything via the physical inputs to wake up the speaker.