BOSS RC-202 Loop Station - Manual (Page 12)

12
For each bank you can make settings for rhythm, looper, external pedals, and effects.
1.
Select the bank for which you want to make settings.
1. Press the [MEMORY] button.
2. Turn the [VALUE] knob.
3. Use the [P. SHIFT] (1)–[DELAY] (8) buttons to select a phrase memory.
Alternatively,
In the Play screen, turn the [VALUE] knob while pressing it.
4.
Press the [SETUP] button.
5.
Press a button to select the category of settings that you want to make.
LOOP
Make looper-related settings
such as recording and playback
method.
FX
Make effect settings.
RHYTHM
Make rhythm-related settings.
CTL
Make controller-related settings
such as for external pedals.
6.
Press the [VALUE] knob to select a parameter, and turn the [VALUE] knob to edit the value.
Reference
For details on parameters and rhythm patterns, refer to “Parameter Guide” (PDF).
7.
Press the [SETUP] (EXIT) button to return to the Play screen.
Saving a Bank
If you select a different bank or turn off the power after editing the bank settings, your changes will be lost. Be sure to save
important data.
1.
Save any of the phrase memories in that bank (p. 10).
When you save a phrase memory, the bank settings are also saved automatically.
Bank Settings
NOTE
* Please be aware that the contents of memory can be irretrievably lost as a result of a malfunction or improper
operation of the unit. You should back up important data as described in “Backing up to your computer” (p. 15).
* All due care is taken during repairs to avoid the loss of data. However, in certain cases, such as when there is damage
to the memory, it may not be possible to restore the data.
* Unfortunately, it may be impossible to restore the contents of data that was stored in the unit’s memory once it has
been lost. Roland Corporation assumes no liability concerning such loss of data.