BOSS RC-202 Loop Station - Manual (Page 19)

Troubleshooting
19
Deutsc
h
Françai
s
Italiano
Español
Por
tug
uês
N
eder
lands
EnglishEnglish
Error Message List
Display Meaning Action
E01
Playback is not possible because the recording time or WAV file
is too long.
The recording time or WAV file length must not exceed three hours.
E02
Playback is not possible because the recording time or WAV file
is too short.
The recording time or WAV file length must be at least 0.1 seconds.
E03 Further overdub is not possible. Save the phrase again.
E04
The maximum recording time is approximately three hours (total
of all phrase memories).
If the maximum recording time is exceeded, recording or
overdubbing might be interrupted because of insufficient
internal memory.
Delete unneeded phrase memories (p. 10), and then try recording
again.
E05
An excessive volume of MIDI messages were received and could
not be processed properly.
Reduce the number or size of MIDI messages transmitted to the
RC-202.
E06
MIDI messages could not be properly received.
Check to make sure that no corrupt MIDI messages are being
transmitted.
Reduce the number or size of MIDI messages transmitted to the
RC-202.
E07
There is a problem with the MIDI cable connection.
Check to make sure the cable has not been disconnected and that
there is no short in the cable.
E08
When saving a phrase memory, you can’t overwrite a phrase
memory in which data was already saved.
Select an empty phrase memory, and then save (p. 10).
E09
The procedure cannot be carried out unless the unit is in the
stopped state.
Stop the unit, then try the procedure again.
E10
Since the track is being played at a much faster tempo than
when it was recorded, it might not play back correctly.
Adjust the tempo.
E11
Since the track is being played at a much slower tempo than
when it was recorded, it might not play back correctly.
E12
This WAV file is unplayable. Check the format of the WAV file.
E90
The RC-202 could not process the data completely.
Lower the performance tempo.
Save the current content to a phrase memory.
Reduce the number of adjustments or changes made with the
RC-202’s knobs and external pedals.
Reduce the number or size of MIDI messages transmitted to the
RC-202.
Ensure that the phrase is not shorter than 0.1 seconds.
E91
It may be that an invalid file was written while connected in USB
mass storage mode (e.g., when writing a WAV file).
Alternatively, you used your computer to format the
“BOSS_RC-202” drive when connected in USB mass storage
mode, causing the RC-202 to stop operating correctly.
In factory reset (p. 13), select “ ALL ” to return the RC-202 to its
factory-set condition.
E97
E98
A problem has occurred with the content of the RC-202’s
memory.
Consult your Roland dealer or local Roland Service.
E99 A problem has occurred in the system. Consult your Roland dealer or local Roland Service.