Electrolux D4100 - Manual (Page 46)

HOW TO FINISH UNPACKING
Place packed cooker next to the cabinet in
which it will be installed.
Remove the cooker packing except for bottom
tray which should be left in position until the
cooker is ready to be fitted into its cabinet.
It is imperative that the cooker is left in the
base to protect both the appliance and the
floor.
Ensure the user is given these operating
instructions.
TOOLS REQUIRED
The following tools will be needed and it helps to
assemble them before starting to install the oven:-
A terminal screwdriver (3mm wide blade)
A pozidrive screwdriver
Pliers
Wirestrippers
Knife
Sidecutters
Adhesive Tape
Tape Measure
MAKING THE ELECTRICAL
CONNECTIONS
PREPARING CABLE
We recommend you use a new length of cable to
ensure your safety.
Ensure you have the correct length of cable
appropriate to the wiring method you are using.
When fitting new cable allow sufficient cable for
removal of the unit at a later date, should it be
necessary.
Score, but do not cut through, around the
sheathing with a knife 100mm (4in) from each
end of the cable and break through to the
encased wires by bending the cable backwards
and forwards to fatigue the sheathing.
Carefully score down from each end of the
cable sheathing along the length of the bare
earth wire (if a cut was made along the length
of the live and neutral wires, it might cut into
their sheathing) to the cuts already made.
Carefully prise open the sheathing at each end
of the cable to expose the encased wiring.
Important: Switch off at mains,
miniature circuit breaker and, if
appropriate, remove fuse before
commencing any electrical work
45