Emerson Radio CKD3810 - Manual (Page 14)

13
Programmed Playback
The CD player in this unit has a 20 track programmable memory which allows you
to program any disc to play just the tracks you want to hear in the exact order that
you want to hear them. You may program a track or tracks to play more than once
if desired.
Note: Programming can only be done while the player is in the Stop mode. If a disc
is playing press the STOP button to stop playback before performing the
programming steps below.
1.) Turn the unit ‘On’, select the CD function and load the desired disc in the
player. Wait until the player reads the disc and the display shows the total track
number.
2.) Press the PROGRAM button. The PROGRAM indicator flashes and the display
shows “ P01 ” indicating that you can select the first track to be programmed.
3.) Press the or buttons to select the first track. When the desired track ck
number appears on the display press the PROGRAM button again. The selected
track is entered in program memory number 1 and the display advances to
“ P02 ”.
4.) Press the or buttons to select the next track to be programmed, and nd
press the PROGRAM button to enter that track in the memory.
5.) Repeat step 4 to program up to 20 tracks in the memory.
6.) After you have programmed all the desired tracks press the PLAY/PAUSE
button to begin programmed playback. The PROGRAM indicator stops flashing
and remains ‘On’. Playback will begin on the first track you programmed and
continue until all programmed tracks have been played.
CKD3810_ib.p65 18/3/2002, 14:10 13