Emerson Radio CKD3810 - Manual (Page 9)

8
OPERATING INSTRUCTIONS
SETTING THE TIME OF DAY
• Connect the power cord to your AC outlet. Make sure to use an outlet that is
always ‘live’. Do not use an outlet that is controlled by a wall switch.
• When the unit is plugged in for the first time the display will show “12:00” (AM).
1.) Press the TIME button. The display begins to flash.
2.) Continue to hold the TIME button and press the / HR button to set the
hour. Be sure to observe the PM indicator to set the hour correctly. If the PM
indicator is ‘On’ the hour displayed is PM.
3.) Press the TIME and / MIN buttons together to set the minute correctly,,
then release all buttons.
SETTING THE WAKE UP TIMES
The unit has two separate wake up alarms that can be set and used independently.
1.) Press and hold the ALARM 1 or ALARM 2 button. The display will change from
the respective time of day to wake up time and begin flashing.
2.) Continue to hold the ALARM 1 or ALARM 2 button and press the / HR
button to set the wake up hour. Set correctly for AM or PM.
3.) Continue to hold the ALARM 1 or ALARM 2 button and press the / MIN
buttons to set the minute correctly, then release all buttons.
Whenever you want to check the respective wake up time setting simply press the
ALARM 1 or ALARM 2 button. The display changes from time of day to wake up
time as long as the ALARM 1 or ALARM 2 button is depressed.
CKD3810_ib.p65 18/3/2002, 14:10 8