Epson 10600 - Manual (Page 11)

4
4 | Introduction
Macintosh System Requirements
To use your printer in either a standalone or peer-to-peer network
environment, your system should include the requirements listed below:
• For USB connection: Power Macintosh ® G3, G4, or iMac ™ series
(System 8.5.1 through 9.x; System 9.2.2 or later recommended)
For IEEE 1394 connection: iMac DV, G3, or G4 series (System 8.6 or
later with FireWire
® Update 2.1 or later)
For 10/100 BaseT Ethernet connection: iMac, G3, or G4 series (System
8.5.1 through 9.x; 9.2.2 or later recommended)
• 350 MHz processor (700 MHz or higher recommended)
• 256MB of RAM (at least 512MB recommended)
• At least 8GB available hard disk space to install the software and process
files (60GB or more recommended)
• Quad-speed (4×) or faster CD-ROM or DVD drive for installing the
printer software
• For USB connection: a compliant USB port and a shielded USB “AB”
cable from Series A (computer) to Series B (printer), up to 6.6 ft
(2 meters) long
For IEEE 1394 (FireWire) connection: a compliant IEEE 1394 port
and a shielded IEEE 1394 cable
For network connection: an RJ-45 Ethernet cable
Note
If you are not using Photo
Printing Accelerator in
your driver (see page 1-33
for details), or if you are
using a software or
hardware RIP, you must
have a Power Macintosh
G4 with a 500 MHz or
higher processor and
512MB RAM to keep the
printer running at full
engine speed.
For optimum
performance, we
recommend the latest
Macintosh system
available with a
FireWire connection.
If you are running System
8.5.1 on an iMac, Apple
recommends that you
download iMac Update
1.1 from their web site.