Electrolux 80850 i - Manual (Page 15)

Operating Instructions
15
Adjusting Rinse Aid Dosing
3 The dose should be adjusted according to the finish and drying results
obtained. The dose is factory set at 4, and can adjusted from 1 to 6.
Gradually increase the dose if there are drops of water or lime spots on
the dishes after washing. Reduce if it there are sticky whitish streaks on
the dishes.
0 1. Turn the lid of the container
¼ of a turn anticlockwise and
remove.
2. Adjust the dose setting with a tea
spoon.
3. Replace the lid and tighten by turn-
ing clockwise.
4. If rinse aid has run out, wipe up with
a cloth.
Setting the Audible Signal for the End of the Wash
Programme
The dishwasher can be set to exit an audible signal at the end of a wash
cycle.
0 1. The dishwasher must be switched off.
2. Press the signal tone and water softener buttons simultaneously and
keep them pressed.
3. Press the ON/OFF button. The LED indicators for the signal tone and
water softener buttons flash.
4. Press the signal tone button again.
The multi-display indicates the current setting:
5. Pressing the signal tone button changes the setting.
6. Once the multi-display indicates the required setting, press the ON/OFF
button. The setting is then saved.
b0
Signal tone switched off
b1
Signal tone switched on (factory setting)