Husqvarna HUV4210-G - Manual (Page 16)

Controls and Indicators
Page 14 2007 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual
NOTE: The key can be removed only when the key switch is in the OFF position.
Electric Vehicles
The key switch is mounted on the dash to the right of the steering column. It has two positions, OFF and ON,
which are clearly labeled. See following NOTE.
NOTE: The key can be removed only when the key switch is in the OFF position.
FORWARD/REVERSE CONTROL
Gasoline Vehicles
The Forward/Reverse handle is located on the seat support panel (Figure 7). The handle has three distinct
positions: F (FORWARD), N (NEUTRAL), and R (REVERSE). Rotate the handle towards the driver (FOR-
WARD) to operate the vehicle in the forward direction, or towards the passenger (REVERSE) to operate the
vehicle in reverse. Husqvarna vehicles operate at reduced speed in REVERSE. The engine can be started
only when the handle is in the straight up position (NEUTRAL). The engine must be at idle before shifting the
Forward/Reverse handle. See WARNING and CAUTION on page 13.
Electric Vehicles
The Forward/Reverse rocker switch is located on the seat support panel (Figure 8). The F (FORWARD) and
R (REVERSE) positions are clearly marked. Push down the FORWARD side of the switch to operate the vehi-
cle in the forward direction, or push down the REVERSE side of the switch to operate the vehicle in reverse.
When the rocker switch is positioned in the NEUTRAL position, with neither side down, the vehicle will not
operate if the accelerator pedal is pressed . The reverse buzzer will sound as a warning when the Forward/
Reverse switch is in the REVERSE position. Husqvarna vehicles operate at reduced speed in REVERSE.
Figure 6 Key Switch
GAS VEHICLE SHOWN