Husqvarna HUV4210-G - Manual (Page 31)

Storage – Gasoline Vehicles
2007 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 29
5. To protect the engine, remove spark plug and pour 1/2 ounce (14.2 mL) of SAE 10 weight oil into the
engine through the spark plug hole. Rotate engine crankshaft by hand several times, then install the
spark plug and tighten to 20 ft-lb (27 N·m).
6. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 48.
7. Perform semiannual periodic lubrication. See Periodic Lubrication Schedules on page 34.
8. Thoroughly clean front body, rear body, seats, engine compartment, and underside of vehicle.
9. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.
RETURNING THE STORED GASOLINE VEHICLE TO SERVICE
1. Restore fuel system to operation (Figure 32, Page 47).
1.1. Remove plug from fuel tank vent.
1.2. Connect vent tube to fuel tank vent.
2. Connect battery cables, positive (+) cable first, and tighten terminals to 12 ft-lb (16 N·m).
3. Completely open the fuel shut-off valve (Figure 17). Make sure the valve is fully open. A partially closed
fuel shut-off valve (Figure 18) combined with the use of the choke can result in a fouled spark plug and
engine failure.
4. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the
carburetor and fuel lines and the engine starts. Turn the engine off. See following NOTE.
NOTE: Due to the oil added to the engine in preparation for storage, engine may smoke excessively for a
short time when it is run for the first time after storage.
5. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 48.
6. Perform the Pre-Operation and Daily Safety Checklist on page 19.
Figure 17 Fuel Shut-off Valve – Open Position Figure 18 Fuel Shut-off Valve –
Partially Closed Position
VIEWED FROM SELECTOR
SIDE OF VALVE
FULL OPEN (ON)
POSITION
VIEWED FROM SELECTOR
SIDE OF VALVE
PARTIALLY CLOSED
POSITION