Husqvarna HUV4210-G - Manual (Page 26)

Bed Latch
Page 24 2007 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual
BED LATCH
See General Warnings on page 9.
The bed latch (1) is located under the front corners of the bed (Figure 15, Page 24) and engages automati-
cally when the bed is closed. To lift the bed, pull the bed latch toward the side of the vehicle and lift the bed.
To close the bed gently lower the bed to a closed position. DO NOT drop the bed. See following WARNING.
ý WARNING
• Keep hands and fingers clear of crush area between the bed and the seat back support.
LOADING AND UNLOADING
ý WARNING
• Firmly engage the park brake before loading the vehicle.
• Do not allow riders in the cargo bed.
• Do not exceed the rated capacity of the vehicle. Rated capacity is for level surfaces only.
• Overloading can affect vehicle handling or cause component failure, resulting in loss of
control of vehicle and possible severe personal injury.
• Reduce vehicle load and speed when driving up or down slopes or on uneven terrain.
• Reduce speed and avoid sudden stops when backing up. Failure to do so may cause the
vehicle to overturn or flip over backwards.
• Avoid stopping on a hill when loaded. If you must stop on a hill, avoid sudden starts, or rolling
backwards and stopping suddenly. Failure to heed this warning may cause vehicle to
overturn, possibly resulting in severe personal injury.
• Do not load the tailgate. The tailgate should be in the upright position and latched securely
while the vehicle is in motion.
• To help avoid shifting the vehicle load and possibly overturning the vehicle, avoid sudden
starts, sudden stops, and abrupt turns.
• The cargo’s center of gravity may affect the handling, steering, and braking of the vehicle.
When the vehicle is loaded, reduce speed and drive slowly in turns.
WARNING CONTINUED ON NEXT PAGE...
Figure 15 Bed Latch
1