If installing on an outlet box – Honeywell CT87A User Manual

Page 4

Advertising
background image

CT87A,B,J ROUND® THERMOSTAT

69-0274-6

4

1. If using the cover ring: Position the cover ring against the wall so

that the arrow in the middle of the cover ring is pointing up.

2. Position the wallplate or subbase.

• If using cover ring: Place the wallplate/subbase over the cover

ring. Rotate the wallplate/subbase until the wiring openings are

aligned and the two screw holes on the left and right side of the

wallplate/subbase align with the screw holes on the cover ring.

You will be inserting screws through these holes into the wall.

• If attaching wallplate directly to the wall: Position so that the

UP indicator on the wallplate is on top.

• If attaching subbase directly to the wall: Position so that the

fan and heating/cooling switches are on the top.

3. Use a pencil to mark the center of the screw holes on the left and

right sides of the wallplate or subbase.

4. Remove the wallplate/subbase and cover ring, and drill two 1/16-in.

holes at the locations you marked.

5. Reposition the cover ring (if used) and wallplate/subbase over the

holes, pull the wires through the wiring opening, and loosely insert

the two 1-in. screws into the drilled holes.

If installing on an outlet box

Refer to Fig. 5 as you work.

Fig. 5. Installing wallplate/subbase on an outlet box (subbase shown).

M20187

OUTLET BOX

SUBBASE

COVER RING

1

THERMOSTAT
WIRING HOLE

THE TWO INNER HOLES ARE USED WITH WALLPLATE.

2

IF OUTLET BOX IS HORIZONTAL, MOUNT COVER RING IN
POSITION SHOWN, BUT FASTEN WITH SCREWS THROUGH "A".

2

1

A

1/2 IN. BINDING
HEAD SCREW (2)

1/4 IN.
ROUND
HEAD
SCREW (2)

Advertising
This manual is related to the following products: