Hitachi 57T600 - Manual (Page 69)

SETUP
69
This function will automatically turn the Projection TV on and off, one time only, every day, or once a
week. This Event Timer is only for ANT A/ANT B. To set Event Timer in ANT C, press the GUIDE but-
ton on the remote control (see page 31-32).
Use THUMB STICK ̄ to select Event 1, 2 or 3.
Use THUMB STICK ̈ to change position of On time, Off time, Antenna, Channel, and On/Off Frequency.
Use THUMB STICK ̆ or ̄ to select the time the TV will turn on and off.
Use THUMB STICK ̆ or ̄ to select the day of the week you want the timer to turn on TV.
Use number buttons to set the channel the TV will tune to when it automatically turns on.
Use THUMB STICK
̆ or ̄ to select mode Once (TV will turn on/off one time only), Daily (TV will turn on/off at the same time every
day), or Weekly-SUN (TV will turn on/off at same time every week).
Press EXIT to quit the menu.
NOTE: 1. The Off Timer will only activate if the TV was turned on by the On Timer and no channel selection was
made after this time. If you change the channel after the On Timer has been activated, the Off Timer will deactivate.
2. If no remote control button is pressed after Event Timer is activated, the TV will automatically turn off after three hours.
Therefore, do not Set Event Timer for more than three hours if you do not plan to control your television with the
remote control.
CAUTION: Do not use your TV as a deterrent when away from home by using the On and Off Timers. For safety, the TV
should be turned off when you are away from home.
Set Event Timer
THUMB
STICK
SELECT
Set The Channels
Set The Clock
Menu Preference
Setup
Set The Inputs
Move SEL Select
Set Event Timer
Set Closed Captions
Setup
Move SEL Return
Set Event Timer
Event 1 --:-- AM --:-- AM
Ant A Ch -- Once
Event 2 --:-- AM --:-- AM
Ant A Ch -- Once
Event 3 --:-- AM --:-- AM
Ant A Ch -- Once
Setup
Move SEL On/Off
Set Event Timer
Event 1 --:-- AM --:-- AM
Ant A Ch -- Once
Event 2 --:-- AM --:-- AM
Ant A Ch -- Once
Event 3 --:-- AM --:-- AM
Ant A Ch -- Once
THUMB
STICK
Return
Set Monitor Out
Upgrades
About Your TV
Please Set Clock First.
If the clock is not set, you can not use this function and the screen below will appear in ANT A and ANT B. The message on the screen
will disappear after 3 seconds, then the screen automatically goes to the clock setup mode (see page 62).
ON-SCREEN
DISPLA
Y