Hitachi 50UX26B/27K - Manual (Page 52)

INITIAL SETUP
52
DOWN ( ) buttons.
If the EXIT button is pressed while the AUTO CHANNEL SET function is engaged,
programming will stop. If two antennas are connected, switch antenna inputs with the
INPUT button and repeat AUTO CHANNEL SET for the second antenna input.
Remember to select the correct SIGNAL SOURCE mode before using AUTO
CHANNEL SET for the second antenna input.
See CHANNEL MEMORY to add or erase additional channels.
CHANNEL MEMORY
Use this function after AUTO CHANNEL SET to add or erase additional channels to the
remote control CHANNEL
or buttons.