Hoover WindTunnel - Manual (Page 3)

3
STEP II Attach handle
4 3
A
2
2 3 Slide handle onto cleaner body. Push bolts into holes on back of
handle. 4
5
5 Place nuts in recessed areas on
front of handle. Hold each nut
in place while tightening each bolt
securely with a Phillips screw driver.
Continued ➜
STEP III Attach hose
8
B
A
10 9
B
Align end of hose with projec-
tions (A) over slots (B) in dirt
duct.
8 9 10
Slide hose into (B) and twist
hose to lock it into place. Lift hose tube cover (C).
Position hose over hose hook(D)
and into hose tube (E).
Remove bag door on cleaner
body by pushing down at top of
door and pulling door outward.
Switch (A) above bag door should
be in OFF position.
6
6 Reposition bag door by fitting
tabs on bottom of door into
opening. Press top of door to snap
securely shut.
7
7 Position cord on back of cleaner
as shown and press cord into
clip.
Note: Hose must be connected as shown for
all operations
E
D C