HONDA FG100 - Manual (Page 31)

UNPACKING
1. Carefully remove the tiller and loose parts from the carton.
2. Remove the loose parts bag. Compare the loose parts with the inventory list below.
3. The tine spacers
and drag bar will not be installed during assembly. Temporarily place the tine
spacers and drag bar in the owner’s manual bag.
Tools Required:
Phillips screwdriver, 7/16 and 9/16-inch wrenches and sockets and a torque wrench.
LOOSE PARTS
Check all loose parts against the following list. Contact your authorized Honda servicing dealer if any of the
loose parts shown below are not included with your tiller.
* The tine spacers are installed for narrow cultivating (see page 16).
** The drag bar is installed in place of the wheel assembly prior to tilling (see page 9).
24 25
Ref. No Description Qty.
1 Upper handlebar 1
2 Right lower handlebar 1
3 Left lower handlebar 1
4 Right carry handlebar 1
5 Left carry handlebar 1
6 Handlebar grip 2
7 Wheel bar 1
8 Inner collar 2
9 Outer collar 2
10 Hex bolt, 3/8-16 x 8 inch 1
11 Washer 2
12 Lock nut, 3/8-16 1
13 Wheel 2
Ref. No Description Qty.
14 Clevis pin, 5/16 x 7/8 inch 1
15 Lock pin 1
16 Lock nut, 1/4-20 3
17 Bolt, 1/4-20 x 6 inch 2
18 Flange bolt, 1/4-20 x 1-1/2 inch 1
19 Pipe plug 1
20 Handlebar bolt, 5/16-18 x 1-1/2 inch 2
21 Handlebar knob 2
22 Tie strap 2
23 Oil bottle 1
24* Tine spacer 2
25* * Drag bar 1
Genuine Oil
10W30 SJ SAE
Initial fill for the
Not for Resale FG100 MINI-TILLER
1
10
11
13 14 15
16
17
18 19 20 21
22
23
24 25
2 3 4 6 5
7
8
9
12 Place with Owner's Manual
ASSEMBLY
FG100 TILLER
29