Hitachi DH 50MB - Manual (Page 13)

13
English
(1) Switching to “hammering”
(a) Pull the selector lever, release lock
and turn it counterclockwise.
(b) Align ▲ of the selector lever with ▲
on the side of the undercover as
illustrated in Fig. 7.
(c) Push in the selector lever to lock it.
NOTE:
Turn the selector lever (do not pull it up)
to check if it is completely locked and
make sure that it does not turn.
(2) When fixing working positions of tools
such as cold chisel, etc.,
(a) Pull the selector lever, release lock
and turn it. Align ▲ of the selector
lever and of the undercover as
illustrated in Fig. 8.
(b) Push in the selector lever to lock it.
(c) Turn the grip as illustrated in Fig. 9
and fix the working position of the
tool.
(d) Switch the selector lever to
“hammring” according to the
procedures mentioned in the above
item (1) and secure the position of
the tool.
5. Install the stopper (Fig. 10)
(1) Loosen the side handle and insert the
straight portion of the stopper into the
handle bolt hole from the front cover.
(2) Loosen the side handle, move the
stopper to the specified position and
rotate the grip of the side handle
clockwise to fix the stopper.
Fig. 7
Undercover
▲
▲
Selector Lever
Fig. 8
▲
Selector Lever
Undercover
Grip
Fig. 9
Stopper
Side Handle
Fig. 10