HP SAP Smart Forms and Zeberea Print - Manual (Page 48)

Driving Zebra Printers from Smart Forms
13760L Page 47
Below is a list of supported command Nodes:
Description Command Node Supported Values
Human Readable S_LZPL_HR System Bar Code Style Name
S_LZPL_HR1
S_LZPL_HR2
S_LZPL_HR2
Print Speed (^PR)
S_LZPL_SETUP_SPD Supports 2,3,4,5,6,8,9,10,11,12
Media Tracking (^MN) S_LZPL_SETUP_MTR N Y W M
(Continuous, Non-Continuous, Web Sensing, Black Mark Sensing)
Media Type (^MT) S_LZPL_SETUP_MT D T (Direct Thermal, Thermal Transfer)
Print Mode (^MM) S_LZPL_SETUP_PM T R P C (Tear off, Rewind, Peel Off, Cutter)
Top Position (^LT) S_LZPL_SETUP_TP Supports -120 to 120
Tear Off Position (~TA) S_LZPL_SETUP_TO Supports -120 to 120
Media Darkness (^MD) S_LZPL_SETUP_MD Range is -30 to 30
Generic commands S_LZPL_SETUP Any ZPL-II Command
Note: If the System Bar Code name used in the Smart Style is entered against
“S_LZPL_HRx” (x=1 to 3) then the Human Readable will be enabled for that specific
object (only human readable below the bar code is supported).
Other ZPL II commands can be added via “Printer Bar Code Objects”, i.e., a circle, box
with rounded corners, RF-ID field or a ZTools bar code! This is also useful for enabling
“box reversing” to support “reverse text” via using the command ^LRY.