HP 3380 - Manual (Page 61)

To load originals into the automatic document feeder (ADF)
input tray
Note ADF capacity is up to 50 sheets of 75 g/m 2 (20 lb) media (depending on the thickness of the
media), or until the ADF input tray is full.
The minimum size for media in the ADF is 127 by 127 mm (5 by 5 inches). For smaller sizes
use the flatbed scanner. The maximum size for media in the ADF is 215.9 by 381 mm (8.5 by
15 inches).
1. Make sure that the flatbed scanner contains no media.
2. Close the flatbed scanner cover and put the top end of the original media stack into the
ADF input tray, with the media stack face-up and the first page to be copied on top of the
stack.
3. Slide the media stack into the ADF until the media does not move any farther.
4. Adjust the media guides until they are snug against the media.
5. The document is now ready to be copied.
CAUTION To prevent damaging the device, do not use an original that contains correction tape,
correction fluid, or staples.
ENWW Loading originals to copy 49