HP 3380 - Manual (Page 73)

Loading originals into the automatic document feeder (ADF)
input tray
Note The ADF capacity is up to 50 sheets of 75 g/m 2 (20-lb) media (depending on the thickness of
the media), or fewer sheets if the stack fills the ADF input tray.
The minimum size for media in the ADF is 127 by 127 mm (5 by 5 inches). For smaller sizes,
use the flatbed scanner. The maximum size for media in the ADF is 215.9 mm wide by 381 mm
long (8.5 by 15 inches).
1. Make sure that no media is on the flatbed scanner.
2. Close the flatbed scanner cover and put the top end of the stack of originals into the ADF
input tray, with the media stack face-up and the first page to be scanned on top of the
stack.
3. Slide the stack into the ADF until it does not move any farther.
4. Adjust the media guides until they are snug against the stack.
5. The originals are now ready to be scanned.
CAUTION To prevent damaging the device, do not use an original that contains correction tape,
correction fluid, or staples.
ENWW Loading originals to scan 61