HP C100/110 - Manual (Page 147)

131
Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
Installing a Hard Disk Drive in Position 3 or Position 4
Perform the following procedure to install a hard disk drive in positions 3 or
4 of the disk tray:
1 Remove the two retaining screws from the disk interconnect board, as shown in
Figure 31.
Figure 31 Removing the Disk Interconnect Board
2 Disconnect any cables from the disk interconnect board.
3 Hold the disk interconnect board on the edges and lift it straight up to remove it,
as shown in Figure 31.