Hitachi 50UX23K - Manual (Page 15)

FRONT PANEL JACKS AND CONNECTIONS - 15 -
Point your Remote at this area when selecting channels, adjusting volume, etc.
1
MAGIC FOCUS
Use this button to adjust your picture quality to optimum performance. (See page 39)
ADJUSTMENT MODE button
This button is for service technicians only. DO NOT press this button. If this button is
accidentally pressed, please turn off your television using the front panel power button.
Your TV will operate normally when you turn it on again.
FRONT INPUT JACKS (for VIDEO :3)
Use these audio/video jacks for a "quick" hook-up from a camcorder or VCR to instantly
view your favorite show or new recording. (Press the AVX button until VIDEO: 3
appears in the top right corner of the TV screen.)
FRONT PANEL JACKS AND CONNECTIONS
The front panel jacks are provided as a convenience to allow easily connect a
camcorder or VCR:
NOTE: Completely insert connection cord plugs when connecting to front panel jacks. If
you do not, the played back picture may be abnormal. If you have a S-VHS VCR, use the
S-INPUT cable in place of the standard video cable.
REAR PANEL JACKS
Click to see Rear Panel Jacks.
Antenna Input / Output
The "ANT" button on the remote control allows you to switch between two separate 75-
Ohm RF antenna inputs, Main (VHF/UHF) and Auxiliary (AUX). The antenna output
labeled "To converter" allows the Main (VHF/UHF) antenna connection to pass directly
to a different source such as a pay-TV cable decoder.