Hitachi 50UX23K - Manual (Page 34)

SET UP - 34 -
Reception channels for each mode are shown at the left.
Refer to your cable or TV guide for channel identification standards.
If certain CATV channels are poor or not possible in the CATV1 mode, set AIR/CABLE
to CATV2.
AUTO PROGRAM
This feature will automatically store active TV channels in CHANNEL MEMORY. This
will allow you to skip over unused channels when using the CHANNEL UP (
) or
DOWN ( ) buttons.
If the MENU button is pressed while the auto programming function is engaged,
programming will stop. If two antennas are connected, switch antenna inputs with the
ANT button and repeat auto programming for the second antenna input.
Remember to select the correct AIR/CABLE mode before using auto programming for
the second antenna input.
See CHANNEL MEMORY to add or erase additional channels.
CHANNEL MEMORY
Use this function after AUTOPROGRAM to add or erase additional channels to the